When opening a specific cac file you get this error

Other calc files open fine

When opening HydraCALC or trying to run a calculation, the dialog boxes below appear. 

"Loading from Master Data Location" 

"LoadRegValue for StrInstallDrive MasterLoad Form|Activaate = C:"

After clicking OK or pressing ENTER, HydraCALC will open or finish up the calculation

When trying to open HydraCALC Sizer, a 'run-time error 76', Path not found error pops up and the program doesn't open.

When attempting to view the Info Sheet, the following error message pops up

A grid system was processed from HydraCAD to HydraCALC but the calc file did not have L (left) and R (right) markers for autopeaking.

Calculation runs through but flow & pressure summary are jibberish.  Such as a 'Flow required of 1.#QO gpm'

Running the 'Calculate Results' command locks up HydraCALC Sizer.

While working on a calc file which is saved to a network location, any changes or revisions where were made, then saved, won't be there when the file is opened again.

File doesn't save

File doesn't update

Column widths are randomly getting larger, enough so that many columns are too wide to be seen

The copy/paste for HydraCALC and HydraLIST issues was a WebRoot issue