AutoCAD Based Cards
Total: 721
* On smaller devices swipe left to view hidden table data
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
|---|---|---|---|---|---|---|
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
| Card 844 View | 3D Modeling (AutoCAD Based) | System Boundary | None | Fatal Error | When trying to insert a System Boundary, the user gets these messages.
|
|
| Card 803 View | 3D Modeling (AutoCAD Based) | Show System Model | None | Fatal Error | When attempting to 'Show Fittings' (SHF command), user gets an AutoCAD Fatal Error. Create 3D Model causes a fatal error
Or no error at all. Autocad freezes then crashes without an error other than the AutoCAD Error Report
A software problem has caused AutoCAD to close unexpectedly |
|
| Card 276 View | 3D Modeling (AutoCAD Based) | Check Elevation | None | None | TOS block looks odd or has unusual insertion point or text is placed far away |
|
| Card 368 View | 3D Modeling (AutoCAD Based) | Check Elevation | None | None | Check Elevation Command > after picking a point Internal error !dbobji.cpp@6861:eNotOpenForWrite and Autocad closes |
|
| Card 389 View | 3D Modeling (AutoCAD Based) | Show System Model | None | None | Upon starting the Show 3D command (S3D) the drawing immediately switches to SE isometric, reports no errors but no 3D piping is visible. Even newly drawn pipe won't elevate.
Drawing successfully elevated to 3D. No errors were found |
|
| Card 267 View | 3D Modeling (AutoCAD Based) | Switch To Edit Mode | None | None | Vertical pipe issue. Switching back to Edit Mode (S2D) leaves HydraPipes in Hydrapipe layer. Then when trying to show system model again (S3D) you get an AutoCAD message box "Please Switch to Edit Mode" |
|
| Card 95 View | 3D Modeling (AutoCAD Based) | Show System Model | None | None | After raising to 3D, you see green lines extending from (0,0,0) to points on the drawing
You can erase the green lines and continue on, this is an annoyance and inconvenience but not really a problem. |
|
| Card 362 View | 3D Modeling (AutoCAD Based) | Show System Model | None | None | Fatal Error |
|
| Card 324 View | 3D Modeling (AutoCAD Based) | Find Defline | None | Unhandled Exception | Unhandled exception when using find defline from the smartool options dialog. if there is any pipe that does not get elevated trying this command from the dialog will cause error smartool options |
|
| Card 520 View | 3D Modeling (AutoCAD Based) | Persistent Model | None | None | Possible duplicate Device @ (0,0,0)
There are 3d solids in the drawing that have no geometry. They must be deleted but cannot be selected with a window. Issue can be caused when a 3D Detail fails to be created properly - process creates a footprint at 0,0,0 with no geometry to be seen. Persistent Model |
|
