A grid system was processed from HydraCAD to HydraCALC but the calc file did not have L (left) and R (right) markers for autopeaking.

Calculation runs through but flow & pressure summary are jibberish.  Such as a 'Flow required of 1.#QO gpm'

While working on a calc file which is saved to a network location, any changes or revisions where were made, then saved, won't be there when the file is opened again.

File doesn't save

File doesn't update

Column widths are randomly getting larger, enough so that many columns are too wide to be seen

The copy/paste for HydraCALC and HydraLIST issues was a WebRoot issue

After running an update to 50.54, user is getting this error when trying to add a fitting by right-clicking the fittings cell, a dialog box pops up saying,  May happen with Pipe Schedule and adding a Pump as well.

File to load paths and Dirs.(AND STRING CONVERSION)
CommandLine... yadda yadda yadda

Primary calc results are shown, and when selecting OK to continue back to the calc input screen, the two messages below are displayed, twice;

"The designated source node was not found in the list of pipes" OK

"Calculation failed for an unknown reason" OK

Process Error Hydcalc

Final printout pages in HydraVIEW have data which looks smushed or overlapping or compressed or garbled or jumbled

When opening HydraCalc v50, you get Run-time error '13' Type mismatch OK

The calc program MAY open but you cannot open any jobs or do anything in the window.

Setting certain pipe diameters with specific pipe types gives an ID of 0.

Eg. 1½" - SCHED 40 shows up as 0 rather than 1.61. n/a HydraCalc