Step 5a.3 "Attaching Elevation of ~ to Node ~~~~

Step 5a.3 "Calculating"

"The specified remote node does not have a k-factor. Please fix your input."

"Calculation failed for unknown reason"

When starting AutoCALC, it stops in the v50 Fuel Gauge at step 1a.4 - Calculating Total Lengths. 

Working on the pipe from node #### to node #### with a fitting string of ...

May be followed by a Runtime Error 13 or Runtime Error 5

Your first step of troubleshooting should be to track down the coordinates of the handles (the 4 to 6 character hex code noted after the word node, or pipe, or fitting.  Search for the command FINDME to get these coordinates.

After entering coversheet data for the Tyco Fluid Delivery Calc, an error message of;

Miscfunc Run-time error '53' File not found *.tych

System seems to hang at this step, but eventually shows the error;

Hydraulic Calculation - The system flow demand of ####.## exceeds the maximum rated flow as indicated in the Pump Curve for the pump with the inlet of PI and outlet of PO.

The calculation will not continue Calculation failed for an unknown reason

May not be 1a.3 or 2.3, could be anywhere along here.

When starting the AutoCALC process, you get this error;

Could not find fitting match for Pump Only/Test Point Please check!!

You also see an Accessing Database window with a partial green progress bar.

No Operating Heads of Flows Found!!  Please check...

No Operating Heads or Flows found!! Please check...

This job has gone 200 or more passes without balancing.

Step 2.3 - After one pass through calculations Miscfunc hangs....

Also possibly "Hydraulic Engine not responding" and a "Runtime Error 62 input past end of file"

Step 1a.3 - Fitting Exchange No replacement fitting name for 22E for Sched-10 Note: This could be any fitting or pipe type described in the error. If you click ok at each error, the process will run through without these fittings

Unhandled exception: Input string not in correct format