AutoCAD Based (Sprinklers)
Total: 32
Page:
* On smaller devices swipe left to view hidden table data
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
|---|---|---|---|---|---|---|
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
| View (card-1305) | Sprinklers (AutoCAD Based) | FSC Setup | None | Message Box | When attempting to create a new FSC definition, you get this error message. Clicking OK closes the command
|
|
| View (card-1304) | Sprinklers (AutoCAD Based) | FSC Setup | None | Other | When inserting a flexible sprinkler connection (FSC) after its setup, you get two error messages Error importing hose over size percent, check your FSC dialog properties Setting Over Percent to 10% Error importing hose under size percent, check your FSC dialog properties Setting Under Percent to 20%
Clicking OK in each window will allow you to continue and insert the FSC detail |
|
| View (card-1302) | Sprinklers (AutoCAD Based) | FSC Insert | None | None | When connecting a hard pipe armover to a flexible sprinkler connection (FSC), the flex hose doesn't continue straight, instead it immediately turns 90° before curving back and down to the sprinkler head.
Even with setting the connection to OVER-DOWN
|
|
| View (card-1291) | Sprinklers (AutoCAD Based) | FSC Insert | None | None | Error encountered when creating an FSC block... Can appear as either of the two shown below:
|
|
| View (card-1287) | Sprinklers (AutoCAD Based) | Insert Sprinkler | Head Block Definition | Sprinkler Not Properly Configured | When inserting a SIDEWALL sprinkler, HydraCAD does not ask for the rotation angle of the sprinkler head, it inserts it at 0°
Ideally, it should ask for the rotation angle of the sprinkler head;
|
|
| View (card-1200) | Sprinklers (AutoCAD Based) | Define Drops/Sprigs Or Ceiling Height | Abacus | Unhandled Exception | When clicking the abacus to enter a length, you get this error;
Unhandled exception has occurred in a component in your application. If you click Continue, the application will ignore this error and attempt to continue. Index and length must refer to a location within the string. Parameter name: length
|
|
| View (card-1122) | Sprinklers (AutoCAD Based) | FSC Insert | None | None | No error reported for FSC even when maximum length is clearly exceeded
If you view the FSC properties, it's possible the HoseLength and MaxNumberOfBends values are not set.
|
|
| View (card-1088) | Sprinklers (AutoCAD Based) | Select Sprinkler | None | Unknown Command | When attempting to setup a sprinkler head, after clicking OK in the definition window, the command prompt looks like this and no sprinkler head is inserted;
|
|
| View (card-1087) | Sprinklers (AutoCAD Based) | Select Sprinkler | None | Crash | Attempting to redefine a sprinkler head with the string 'flex' in the name/description will crash with a BAD SSGET error message if the sprinkler was not set up as an older style HydraCAD flex head
|
|
| View (card-1028) | Sprinklers (AutoCAD Based) | Insert Sprinkler | None | 0 | When trying to insert a sprinkler head, this window pops up;
Pick head insertion point. Pick any point besides endpoint to break into pipe. Can't find file in search path *Invalid* |
|
Page:
