When trying to insert a newly defined Flexible Sprinkler Connection, an unhandled exception dialog box appears.

When trying to open the dialogue box to define a Flexible Sprinkler connection, the following message box error appears. 

Could not find file; FSC-INSERTDEFLINE.txt

Calculation process stops at Step 1a.4, then runtime error 13, Type Mismatch

Runtime Error 3167. Error message: Record has been deleted

After running an update to 50.54, user is getting this error when trying to add a fitting by right-clicking the fittings cell, a dialog box pops up saying,  May happen with Pipe Schedule and adding a Pump as well.

File to load paths and Dirs.(AND STRING CONVERSION)
CommandLine... yadda yadda yadda

When attempting to 'Show Fittings' (SHF command), user gets an AutoCAD Fatal Error.

Create 3D Model causes a fatal error

 Or no error at all.  Autocad freezes then crashes without an error other than the AutoCAD Error Report

A software problem has caused AutoCAD to close unexpectedly

Failed to initialize the add-in "HydraTools" 

The Valve Selector is not displaying properly on 4K monitors (menu items and minimize/maximize/close buttons are not showing up, text and graphics are scaled incorrectly, general look and feel does not match the documentation, etc.).

Hydratec Security Lock Error

•      Driver Defective. Uninstall, then reinstall the Sentinel Driver. (FF60).
•      No hardware lock. Make sure your hardware lock is firmly attached to a working port. (FF3).
•      If using a Hardware lock: Bad hardware lock found. Unable to read it properly. (RH60) (RSN60)

For example:

when picking New Take Off Sheet

When picking the continue button one gets an error message

"Unhandled Exception...

Item has already been added.  Key in Dictionary. 'a number' Key being added: 'same number'

Bad location of K-Factor

Upon starting the Show 3D command (S3D) the drawing immediately switches to SE isometric, reports no errors but no 3D piping is visible.  Even newly drawn pipe won't elevate.

Drawing successfully elevated to 3D. No errors were found

Related HydraCARD: #853

https://hydracards.hydratecinc.com/cards/card-853

Call from AutoList::AddLineItemsToDatabase DAO Error changes requested to table not successful - create duplicate values in the index, primary key.... The line it failed to write is logged in C:\HES\TEMP\DAOUpdateError.txt Also: DAO Server Error RSU Update Call from Autolist DAO Error

When using the Figure Head Area tool, you get this error

Error during APQ insert - Microsoft VisualBasic ErrObject

Error during LoadAPQFile - eFileNotFound

Error during InsertAPQandTEXT

File name asked for does NOT exist

FitExch.dat 1.a.1

Create 3D Hangers command did not created 3D hangers for the #01B hanger assembly but it did for all other hanger assembly types. #01B 3D hanger information is not in the DAT file. HydraCAD v50

"AutoLIST Failed!... Please run Listing CheckUps"

This message is shown when running the AutoLIST process, but checkups didn't find any errors AutoLIST Failed

Step 2.3 - After one pass through calculations Miscfunc hangs....

Also possibly "Hydraulic Engine not responding" and a "Runtime Error 62 input past end of file"