When trying to load into FIG Trees, user will either get a; Runtime Error 6 (Overflow) or; Error in Form 4 - Form Load, the application cannot continue Runtime Error 6

AutoList begins and just cycles, does not complete and open HydraList. sits spins loops finishes cycles

When attempting to run AutoLIST, an error message says; Error: Unable to insert cut length dimensions! Unable to insert cut 

You may also see this message;

Re-run Autolist with the drawing starting on the ground, Current run will not include any FSC information in the MISC tab in HydraLIST

Run-time error 70 Permission denied Runtime Error 70

Call from 'AutoList::CleanupDatabase (hangerHeaderDB)' DAO Error The changes you requested to the table were not successful.... DAO error

When attempting to run AutoLIST checkups and selecting a boundary, user gets an error similar to the one below; [Exception in fs_util.arx ARX Command] Unhandled Exception C00000005 (Access Violation Writing 0x9485ad10) at address 7720F86h OR Unhandled Exception in FS_UTIL.ARX and/or ADS request. Unhandled Exception

Error No Tags Found No Tags Found

Unhandled exception E was erased Unhandled exception

Field is too small to accept the amount of data you attempted to add. Try inserting or pasting less data. Runtime Error

"AutoLIST Failed!... Please run Listing CheckUps"

This message is shown when running the AutoLIST process, but checkups didn't find any errors AutoLIST Failed