Revit Based Cards
Total: 218
* On smaller devices swipe left to view hidden table data
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
|---|---|---|---|---|---|---|
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
| Card 1190 View | HydraCALC (Revit Based) | Hydraulic Calculations | None | None | Unhandled Exception - System.FormatException: Input string was not in a correct format
|
|
| Card 1168 View | HydraCALC (Revit Based) | Hydraulic Calculations | Continue | None | Calc stops at Step 2.3 (Can also show Run-time error 62)
|
|
| Card 1150 View | HydraCALC (Revit Based) | Hydraulic Calculations | None | None | Autodesk.Revit.Exceptions.FileNotFoundException: C:\HES\Hydratec for Revit\DATA\Families\2022\Annotation\Hydraulic Referece Point - HydraCAD.rfa
|
|
| Card 1149 View | HydraCALC (Revit Based) | Define Supply | None | Command Failure For External Command | Revit could not complete the external command... Autodesk.Revit.Exceptions.InvalidOperationException
|
|
| Card 1117 View | HydraCALC (Revit Based) | Hydraulic Calculations | None | None | When trying to run a calc for the system, this error appears:
|
|
| Card 1111 View | HydraCALC (Revit Based) | Hydraulic Calculations | Load Defaults | None | Unable to load defaults during HydraCALC Setup. Occasionally will give an error, but most commonly nothing will be filled in.
|
|
| Card 1109 View | HydraCALC (Revit Based) | Supply Point | None | Command Failure For External Command | Revit could not complete the external command... No work plane set in current view
|
|
| Card 1107 View | HydraCALC (Revit Based) | Renumber Ref Points | None | Command Failure For External Command | Revit could not complete the external commad... Method not found
|
|
| Card 1079 View | HydraCALC (Revit Based) | Hydraulic Calculations | Continue | None | Failure at Step 5a.3b |
|
| Card 1061 View | HydraCALC (Revit Based) | Hydraulic Calculations | Continue | Runtime Error |
Calculation stops at Step 1a.4 - calcing total lengths There is also Runtime error 5 invalid procedure call or argument |
|
