HydraLIST input for pipe type is reported as "FITTING" and not the letter of the requested pipe type. See the "Error Circles" on drawing at the fitting where the listing instruction expects to have couplings cut in. (such as Grooved Elbow or Grooved Tee) 1 Typical Error Circle Message: Coupling expected but not found for a '????????'. Insert coupling or change fabrication method 2 Typical Error Circle Message: Takeout of fitting does not match takeout expected for a '????????'. Change fitting or fabrication method

AutoCAD Error Aborting FATAL ERROR: Unhandled Access Violation Reading 0x00e0 Exception at [hex code here] Acad 2019 hex code; 2D92713Eh Fatal Error

Hex code a51b726eh

When attempting to run AutoLIST checkups and selecting a boundary, user gets an error similar to the one below; [Exception in fs_util.arx ARX Command] Unhandled Exception C00000005 (Access Violation Writing 0x9485ad10) at address 7720F86h OR Unhandled Exception in FS_UTIL.ARX and/or ADS request. Unhandled Exception

When attempting to run AutoLIST, an error message says; Error: Unable to insert cut length dimensions! Unable to insert cut 

You may also see this message;

Re-run Autolist with the drawing starting on the ground, Current run will not include any FSC information in the MISC tab in HydraLIST

When trying to load into FIG Trees, user will either get a; Runtime Error 6 (Overflow) or; Error in Form 4 - Form Load, the application cannot continue Runtime Error 6

AutoCAD Error Aborting FATAL ERROR: Unhandled Access Violation Reading 0x00e0 Exception at d65273feh Fatal Error

When starting the Autolist process, you get the error;

AutoList Error 101:  Could not read fitting group name.  Fix your Fitting Mapping in the HydraLIST toolbar

After clicking OK, you get this next

AutoLIST Error!!  AutoLIST failed!...  Please run Listing Checkups

Call from 'AutoList::CleanupDatabase (hangerHeaderDB)' DAO Error The changes you requested to the table were not successful.... DAO error

Error is V50 Drops

"AutoLIST Failed!... Please run Listing CheckUps"

This message is shown when running the AutoLIST process, but checkups didn't find any errors AutoLIST Failed