AutoCAD Based (Piping)
Total: 51
* On smaller devices swipe left to view hidden table data
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
|---|---|---|---|---|---|---|
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
| View (card-337) | Piping (AutoCAD Based) | Size Pipe Setup | None | None | Some pipe sizes have the diameter and length attributes switched in their order |
|
| View (card-336) | Piping (AutoCAD Based) | Insert One RN | None | None | Riser Nipple cut dimension changed to the wrong value after going into the 3D System Model. The Riser Nipple show the wrong takeout value for the sp TakeOut & ep TakeOut properties. This was caused by the SHOW FITTINGS command. HydraCAD v5x.any |
|
| View (card-332) | Piping (AutoCAD Based) | Size Pipe Setup | None | None | ATTDISP setting is wrong. |
|
| View (card-314) | Piping (AutoCAD Based) | Move Line | None | None | Rounding issue |
|
| View (card-302) | Piping (AutoCAD Based) | Size Pipe Setup | None | None | Cannot insert pipe diameters or cut in couplings that also insert pipe diameters. |
|
| View (card-300) | Piping (AutoCAD Based) | Riser Nipple Setup | None | None | 1. the v50 drawing does not have the block vp defined |
|
| View (card-296) | Piping (AutoCAD Based) | Size Pipe Setup | None | None | 1)missing pipe x block 2) bad block Command Prompt AutoCAD 2009,2010 |
|
| View (card-286) | Piping (AutoCAD Based) | Schedule Sizes | None | None | Possible bad ceiling defline |
|
| View (card-279) | Piping (AutoCAD Based) | Riser Nipple Setup | None | None | bad UCS setting select vp |
|
| View (card-274) | Piping (AutoCAD Based) | Riser Nipple Setup | None | None | Riser Nipple center to center and cut dimension properties are both on the same layer. Turn off SPRKDATB and cut dimension does not turn off. SPRKDATB layer did not exist when riser nipple was inserted or a V45 template was used to start the V50 or V51 drawing or drawing was converted from V45 to V50 or V51 HydraCAD v5x.any |
|