AutoCAD Based (Calculations)
Total: 118
* On smaller devices swipe left to view hidden table data
Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
---|---|---|---|---|---|---|
Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
View (card-306) | Calculations (AutoCAD Based) | Start Autocalcs | None | None | Setting incorrect |
|
View (card-273) | Calculations (AutoCAD Based) | Start Autocalcs | None | None | The regisrty BOUNDS entry cuts off the bottom of the dialog box. V50 |
|
View (card-240) | Calculations (AutoCAD Based) | Start Autocalcs | Calc Area # | None | Possibly a crash when dialog is minimzed For example - with autocalc - view flowing paths crashes, then the AutoCALC dialog box is minimized HydraCad v50 |
|
View (card-143) | Calculations (AutoCAD Based) | Start Autocalcs | None | None | x Zero length pipes found in system model YES will cancel... No will allow... |
|
View (card-141) | Calculations (AutoCAD Based) | Start Autocalcs | Calc Area # | Message Box |
System seems to hang at this step, but eventually shows the error; Hydraulic Calculation - The system flow demand of ####.## exceeds the maximum rated flow as indicated in the Pump Curve for the pump with the inlet of PI and outlet of PO.
The calculation will not continue Calculation failed for an unknown reason May not be 1a.3 or 2.3, could be anywhere along here. |
|
View (card-138) | Calculations (AutoCAD Based) | Start Autocalcs | Calc Area # | Missing File |
File name asked for does NOT exist FitExch.dat 1A.1 |
|
View (card-137) | Calculations (AutoCAD Based) | Start Autocalcs | Finish Area | None | Unhandled Exception When clicking the 'Finish Area #' button at the completion of the AutoCALC process, a diablob box pops up; "Object reference not set to an Instance of an object" Just in time JIT Just-in-time System.NullReferenceException: CalcingNameSpace.AutoCalcForm.redButton |
|
View (card-136) | Calculations (AutoCAD Based) | Calc Check Ups | None | None | Running AutoCALC checkups on a drawing causes AutoCAD to crash out AutoCAD Application has stopped working A problem caused the program to stop working correctly. Windows will close the program and notify you if a solution is available. |
|
View (card-135) | Calculations (AutoCAD Based) | Start Autocalcs | None | None | During the AutoCALC process, it gets hung up at step 5a.3b. Re-Ordering Pipe Paths - Phase 2
|
|
View (card-134) | Calculations (AutoCAD Based) | Start Autocalcs | Finish Area | None | After 'finishing area' then exiting out of the Calc Setup screen, no HYD2 (white) reference points are inserted on the drawing Missing Reference Points No Reference Points |