Hydratec Inc.

Need to save a card for later?

Create a bookmark folder in your browser of choice (Chrome, Firefox...), and save individual cards in your bookmarks to view here later.

AutoCAD Based 3D Modeling (Ribbon/Toolbar/Location)

Button: Show System Model

Description:

The process to make the 3D model takes less than 1 millisecond and says it's successful, but after switching to the isometric view, no 3D pipes have been created.  


Drawing successfully elevated to 3D. No errors were found

ALSO SEE;

HydraCARD: #389

https://hydracards.hydratecinc.com/cards/card-389

Solutions:

Cause:

Check VPs to see if they have PROPERTIES using the Edit RN tool.  Double-click the VP (or triple-click on older HydraCADs) and check properties.  Notice in the image below; length, diameter and type are all blank.

 

Solution:

ERASE the bad VPs and re-insert them, then try again.

At this time, it's unknown how it's possible to delete the properties of the VP.

Updated: Feb. 2, 2024, 11:37 a.m. Created: April 28, 2020, 2:06 p.m.