AutoCAD Based (Calculations)
Total: 122
* On smaller devices swipe left to view hidden table data
Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
---|---|---|---|---|---|---|
Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
Card 94 View | Calculations (AutoCAD Based) | Calc Check Ups | None | None | Upon starting the Checkup command for AutoCalc, the command starts but stops. The Command Prompt says; "Initializing... Checking to make sure heads are in the right layer...bad argument type: stringp nil" As a side note, the user's drawing had multiple repeat head definition boxes (blue boxes in ACC1 layer). These were cleaned up (deleted) and the heads redefined. The AUDIT command was run after the cleanup |
|
Card 92 View | Calculations (AutoCAD Based) | Start Autocalcs | None | None | Step 1a.3 - Fitting Exchange No replacement fitting name for 22E for Sched-10 Note: This could be any fitting or pipe type described in the error. If you click ok at each error, the process will run through without these fittings |
|
Card 91 View | Calculations (AutoCAD Based) | Start Autocalcs | None | None | Sizes show in schdule as 1/2" each time schedule is loaded even if reset by user. |
|
Card 90 View | Calculations (AutoCAD Based) | Start Autocalcs | None | None | Pick Start AutoCalc and nothing happens - NIL shows on command line |
|
Card 89 View | Calculations (AutoCAD Based) | Start Autocalcs | Calc Area # | None | Runtime Error 52 File not found |
|
Card 87 View | Calculations (AutoCAD Based) | Start Autocalcs | None | None | Value of '3' is not valid for "Value". Value should be between minimum and maximum. Parameter name: Value component |
|
Card 85 View | Calculations (AutoCAD Based) | Start Autocalcs | None | None | When starting AutoCalc, the following error message appears: You have more than ONE Water Supply for these calculations... You have more then ONE Water Supply for these calculations... multiple source point |
|
Card 84 View | Calculations (AutoCAD Based) | Start Autocalcs | Finish Area | None | Pipe sizes and lengths do not return to drawing. Pipe sizes disaprear |
|
Card 81 View | Calculations (AutoCAD Based) | 3-D Flow Diagram | None | None | 3D Flow diagram missing direction arrows and flows |
|
Card 80 View | Calculations (AutoCAD Based) | Start Autocalcs | None | Unhandled Exception | Unhandled Exception: eWasErased Finishing an Area after calculating. Hangs up in Size Pipe from Schedule |