Hydratec Inc.

Need to save a card for later?

Create a bookmark folder in your browser of choice (Chrome, Firefox...), and save individual cards in your bookmarks to view here later.

AutoCAD Based 3D Modeling (Ribbon/Toolbar/Location)

Button: Show System Model

Description:

All SPRKDATA diameters are set to ? while cut diameters are still correct. Not sure of cause.

Solutions:

Cause:

All SPRKDATA diameters are set to ? while cut diameters are still correct. Not sure of cause.

Solution:

1. Erase all PIPEX blocks in the SPRKDATA layer by using Erase-by-Layer (EBL) command. I chose an area within your system boundary. 2. Type in PROPERTIES to bring up the Prop tab 3. Pick Quick Select and select all your pipex blocks by setting the box thusly: 4. Then pick the LAYER item on the Prop tab and set it to SPRKDATA. This takes care of the block insertion layer 5. Now, close the Prop tab and type in BATTMAN. Set it as follows, and pick SYNC and OK. This puts the attributes in the SPRKDATA layer 6. Now, elevate the drawing to 3D, This will put correct the lengths of the PIPEX blocks 7. You can now list it and get your cut lengths back

Updated: Feb. 27, 2024, 3:07 p.m. Created: March 1, 2019, midnight