Hydratec Inc.

Need to save a card for later?

Create a bookmark folder in your browser of choice (Chrome, Firefox...), and save individual cards in your bookmarks to view here later.

AutoCAD Based Piping (Ribbon/Toolbar/Location)

Button: Riser Nipple Setup

Description:

Riser Nipple center to center and cut dimension properties are both on the same layer. Turn off SPRKDATB and cut dimension does not turn off. SPRKDATB layer did not exist when riser nipple was inserted or a V45 template was used to start the V50 or V51 drawing or drawing was converted from V45 to V50 or V51 HydraCAD v5x.any

Solutions:

Cause:

Riser Nipple center to center and cut dimension properties are both on the same layer. Turn off SPRKDATB and cut dimension does not turn off. SPRKDATB layer did not exist when riser nipple was inserted or a V45 template was used to start the V50 or V51 drawing or drawing was converted from V45 to V50 or V51
Solution:

Rebuild the layers so that SPRKDATB layer exists. Raise the drawing into the System Model and then Switch to Edit Mode. The riser nipples will now have the center to center dimension in SPRKDATA layer and the cut dimension in the SPRKDATB layer.
Updated: April 1, 2024, 12:10 p.m. Created: March 1, 2019, midnight