File name asked for does NOT exist

FitExch.dat 1A.1

Step 1a.10 - "Attaching Node 2 Elevations" User ID Duplicated Dwg ID Dup for User ID

Duplicated hydraulic ref points

Drawing seems fine with no errors but opens to a blank HydraCALC screen

System seems to hang at this step, but eventually shows the error;

Hydraulic Calculation - The system flow demand of ####.## exceeds the maximum rated flow as indicated in the Pump Curve for the pump with the inlet of PI and outlet of PO.

The calculation will not continue Calculation failed for an unknown reason

May not be 1a.3 or 2.3, could be anywhere along here.

Water supply test point not connected to a pipe. Reinsert water supply\test point

3D Flow diagram missing direction arrows and flows

After calc Area # is picked, dialog box runs through gathering information and closes with message "Failed to create file to send to calcs....Exiting"

Runtime Error 457 - This key already associated with an element of this collection

"Hydraulic Engine not responding" and then an "Error 62 input past end of file" usually happens on 2nd area run through

Unhandled Exception: Index was outside the bounds of the array

x Zero length pipes found in system model YES will cancel... No will allow...

Call from 'AutoList::CleanupDatabase (hangerHeaderDB)' DAO Error The changes you requested to the table were not successful.... DAO error

Error is V50 Drops

"AutoLIST Failed!... Please run Listing CheckUps"

This message is shown when running the AutoLIST process, but checkups didn't find any errors AutoLIST Failed

Runtime Error 5 when opening HydraLIST during the AutoLIST process. Error 5

Run-time error 484

Problem getting printer information from the system.  Make sure the printer is set up correctly

Hydraview cannot read the printer drivers. Could be a printer, copier, scanner, fax machine.

Possibly a folder marked as "hidden" in Autocad.

Area # section is blank or missing remote areas in the AutoCalc Setup dialog box. Area number is not recognized

The specified remote node does not have a k-factor. Please fix your input. On Pass 1 Calculation Failed for an unknown reason.

Step 5a.3b - Hangs up reordering Pipe Paths