When attempting to run AutoLIST checkups and selecting a boundary, user gets an error similar to the one below; [Exception in fs_util.arx ARX Command] Unhandled Exception C00000005 (Access Violation Writing 0x9485ad10) at address 7720F86h OR Unhandled Exception in FS_UTIL.ARX and/or ADS request.

Field is too small to accept the amount of data you attempted to add. Try inserting or pasting less data. Runtime Error

Create 3D Hangers command did not created 3D hangers for the #01B hanger assembly but it did for all other hanger assembly types. #01B 3D hanger information is not in the DAT file. HydraCAD v50

When in the Pipe Model Settings window (Setup window in Navis toolkit), the user cleared the text box for "Layer Name prefix" Dialog Box Acad 2016+

Unknown n/a Pipe diameters 53+

Run-time error 70 Permission denied Runtime Error 70

??? Connection Failed listing tags

older or bad file inserting 52

HydraLIST input for pipe type is reported as "FITTING" and not the letter of the requested pipe type. See the "Error Circles" on drawing at the fitting where the listing instruction expects to have couplings cut in. (such as Grooved Elbow or Grooved Tee) 1 Typical Error Circle Message: Coupling expected but not found for a '????????'. Insert coupling or change fabrication method 2 Typical Error Circle Message: Takeout of fitting does not match takeout expected for a '????????'. Change fitting or fabrication method

Pretty Pipes requires line type TRACKS. This line type is missing from the drawing. Unhandled Except. v50

1) Inserting 3d fittings is very slow & you must hit enter several times to get through the command. Must pick Enter or OK for each fitting. 2) Could also be related to an AutoCAD drawing variable setting.

Screen shows calcing Pump, then getting error 53. Pump calc not calcing Run time 53

Unhandled Exception has occurred in a component in your application

Index was out of range. Must be non-negative and less than the size of the collection.

AutoCAD entities too far out in space for revit to handle

Possibly a rogue lisp routine causing ours not to work HydraCAD v50.any

1. Bad PRETTYPIPES.DAT file

2. corrupt xrefs

3. Irregular linetypes in the drawing.

4. Bad Hcad_Toolbox.dll file eBadLinetypName V53.04

3dends folder or files missing unhandled exception

Interestingly PDMODE is set to 1. This means that there is no node point at the insertion of these sizes, so the sizes are not found.

All pipe is in the branch line (SPRKDATB) layer solid pipes 3d modeling

Setting incorrect