Revit (HydraCALC)
Total: 39
Page:
* On smaller devices swipe left to view hidden table data
Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
---|---|---|---|---|---|---|
Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
View (card-1168) | HydraCALC (Revit) | Hydraulic Calculations | Continue | None | ||
View (card-1150) | HydraCALC (Revit) | Hydraulic Calculations | None | None | Autodesk.Revit.Exceptions.FileNotFoundException: C:\HES\Hydratec for Revit\DATA\Families\2022\Annotation\Hydraulic Referece Point - HydraCAD.rfa |
|
View (card-1149) | HydraCALC (Revit) | Define Supply | None | Command Failure For External Command | Revit could not complete the external command... Autodesk.Revit.Exceptions.InvalidOperationException |
|
View (card-1117) | HydraCALC (Revit) | Hydraulic Calculations | None | None | When trying to run a calc for the system, this error appears: |
|
View (card-1111) | HydraCALC (Revit) | Hydraulic Calculations | Load Defaults | None | Unable to load defaults during HydraCALC Setup. Occasionally will give an error, but most commonly nothing will be filled in. |
|
View (card-1109) | HydraCALC (Revit) | Supply Point | None | Command Failure For External Command | Revit could not complete the external command... No work plane set in current view |
|
View (card-1107) | HydraCALC (Revit) | Renumber Ref Points | None | Command Failure For External Command | Revit could not complete the external commad... Method not found |
|
View (card-1079) | HydraCALC (Revit) | Hydraulic Calculations | Continue | None | Failure at Step 5a.3b |
|
View (card-1061) | HydraCALC (Revit) | Hydraulic Calculations | Continue | Runtime Error | Calculation stops at Step 1a.4 - calcing total lengths There is also Runtime error 5 invalid procedure call or argument |
|
View (card-1031) | HydraCALC (Revit) | Equivalent Length | None | Command Failure For External Command | Revit could not complete the external command... System.NullReferenceException |
Page: